JUKI LK-1900A User Manual

− 45 −
[9] OTHERS
1. Setting the DIP switch
When “4” of DIP switch w on SDC circuit board q is
turned ON, the penetrating force is increased. Turn it
ON when the penetrating force is insufficient.
Turn OFF all DIP switches other than the switch above.
Perform the changeover of DIP switch
after turning OFF the power.
Be very careful of the heat of the main
shaft motor.
Turn OFF all DIP switches of MAIN p.c.b.
q
w
SDC p.c.b.
MAIN p.c.b.

JUKI LK-1900A Specifications

General

Stitch Type	Lock Stitch
Power Consumption	550 W
Thread Take-up	Rotary type
Lubrication	Automatic
Needle Type	DP×5
Presser Foot Lift	17 mm
Needle Size Range	#11 - #18
Presser Foot Lift Type	Automatic / Manual
Bobbin	Rotating hook
Motor	Servo motor