DETAILED CONTROLS AND GAUGES OPERATION
3-104
Antenna
Before transporting the machine putting it inside a building, stored the antenna to prevent any interference.
Stow the antenna as follows.
1. Loosen antenna mounting bolt (1) and store the antenna at
position (A).
2. Tighten bolt (1).
Use Radio with Care 3
q To ensure safety, always keep the sound to a level where it is possible to hear outside sounds during operation.
q If water gets into the speaker case or radio, it may lead to an unexpected failure, so be careful not to get water
on the equipment.
q Do not wipe the scales or buttons with solvent such as benzene or thinner. Wipe with a dry soft cloth. If the dirt
cannot be removed easily, soak the cloth with alcohol.
q When the battery is replaced, the settings for the preset buttons are all cleared, so set them again.
Space for radio cassette 3
The radio cassette is not factory fitted. If fitment is required
then remove front cover and connect speaker wires and aerial
to radio cassette.
Please contact your distributor for a fitting instruction.
NOTE: If radio is fitted in this location, do not operate radio in
LH console.
COVER
To Next Page
Loading...
