MAINTENANCE 4.6 LUBRICATION AND MAINTENANCE SCHEDULE
319
4.6.3 PERIODIC SERVICING SCHEDULE
Service Intervals Service Point Service See
Engine Air Cleaners Maintenance page 335
Swing circle toothing
Immediately apply grease if bare
spots are visible
page 339
When necessary Automatic lubrication systems
Fill grease containers
Clean or replace filter elements
page 341
Track rollers If leakage occurs replace
Carrier rollers floating seals and fill with GL page 345
Guide wheels ISO VG CLP 220
Cold starting aid Replace fluid cartridges page 347
Every 10 operating
hours or daily
Excavator Walk-around inspection page 349
Working attachment
Check grease injectors of auto-
matic lubrication system. Check for
proper lubrication.
page 351
Swing circle
Check grease injectors of auto-
matic lubrication system. Check for
proper lubrication.
page 355
Air cleaners Clean pre-cleaner page 357
Radiators Check coolant level page 359
Track groups Clean, esp. in winter page 359
Engines Check oil level (1)
Fire detection and actuation
system
Inspection (2)
Swing gears and Motor adapter
housings
Check oil levels page 361
Every 50 operating
hours or weekly
Travel gears, Motor adapter
housings and Final drives
Check oil levels page 365
PTO’s (Pump distributor gears) Check oil level page 371
Hydraulic access ladder Check safety sensor page 375
Hydraulic oil cooler and radiator Check and clean as necessary page 377
(1) Perform maintenance according to separate Engine
Operation an Maintenance Manual filed in volume 2
binder.
(2) Perform inspections according to the separate Manual
”FIRE DETECTION AND ACTUATION SYSTEM” filed
in volume 2 binder.
To Next Page
Loading...
Need help?
General
