ADJUSTMENTS PRIOR TO MACHINE START
5-7
ADJUSTING THE STEERING COLUMN
• Do not change the angle of inclination of the steering col-
umn while you are driving, since this may lead to severe
accidents!
• Stop the machine, before you change the angle of inclina-
tion of the steering column.
You may use this lever for continuous adjustment of the steering
column’s (1) angle of inclination. (Adjustment range 4.92 in (125
mm)).
Proceed as follows:
1. Push down the locking lever (2).
2. Adjust it in such a way that you can reach the steering wheel
from a comfortable seating position while at the same time
having an optimum view of the work unit. Hold the steering
wheel in this position.
3. Pull up the locking lever again to lock the steering column in
this position.
ADJUSTING THE ARMREST
Proceed as follows to adjust the height of the armrest (1):
1. Loosen the screw (2).
2. Either pull out or push back the armrest to reach the multi-
functional lever. Your forearm should rest on the armrest at
an angle of 90° to your upper arm.
3. Re-tighten the screw.
ADJUSTING THE REAR-VIEW MIRRORS
Sit down on the driver’s seat and adjust the rear-view mirrors to
their required positions. You should be able to view the traffic
coming from behind without having to change your seating posi-
tion.
75_281
1
2
75_01
12
To Next Page
Loading...
Need help?
General
