MAINTENANCE BASICS
7-13
WELDING INSTRUCTIONS
• Set the engine start switch to switching position '0' (OFF).
• Apply only briefly a voltage of more than 200 V.
• Connect the earthing cable at a distance of max. 3.28 ft
(1 m) to the area to be welded.
• There must be no gaskets or bearings between the welding
area and the mass point.
• There must be a minimum distance of 3.28 ft (1 m) between
the welding area and the battery.
• Do not weld lines or pipes containing fuel or oil.
To Next Page
Loading...
