BRAKING
5-23
STOPPING
Avoid abrupt stopping. Proceed as follows, if you want to stop
the machine:
1. Release the accelerator pedal and press down the brake
pedal.
2. Set the drive direction switch into its neutral position ‘N’.
3. Apply the parking brake.
4. Lower the work unit onto the ground.
• Unintentional activation of the multifunctional-lever of the
equipment may lead to accidents!
Beforeyouleavethecab,turnthelockingleverforthe
work hydraulic system into position ‘1’. As a result, the
work hydraulic system is blocked.
5. Protect the work hydraulic system against unintentional acti-
vation by turning the locking lever of the work hydraulic sys-
tem into position ‘1’.
PARKING THE MACHINE ON A SLOPE
Whenever possible, stop the machine on level ground. If you
have to park the machine on a slope, it is required that you park
it in such a way that the front section (work unit) points downhill.
Lower the work unit onto the ground. Block the wheels with
wheel chocks (1).
75_02
75_154d
To Next Page
Loading...
Need help?
General
