TROUBLESHOOTING
6-13
STARTING THE ENGINE
Theengineofthemachinewiththechargedbatterymustrunat
high idle-running speed. Start the engine of the machine with the
discharged battery. If the engine does not start up immediately,
wait at least two minutes, before you make a second attempt.
DISCONNECTING THE BATTERY JUMPER
CABLE
• Danger of short-circuit! When disconnecting the cables,
pay attention not to let the cable ends touch each other or
the machine. When the cable ends touch each other or the
machine, a short-circuit is produced which may damage
parts of the electrical system!
When disconnecting the cables, pay attention not to let
the cable ends touch each other or the machine.
After starting of the engine, disconnect the battery jumper cables
by reversing the steps you performed to connect the cables.
1. Disconnect one clamp of the battery jumper cable from the
engine block.
2. Disconnect the other clamp of the battery jumper cable from
the negative terminal (-) of the charged battery.
3. Disconnect the clamp of the battery jumper cable from the
positive terminal (+) of the charged battery.
4. Disconnect the other clamp of the battery jumper cable from
the positive terminal (+) of the discharged battery.
To Next Page
Loading...
Need help?
General
