WHEELS, TIRES 15
81
S04157-11
–
Clean the thread of the wheel spindle and screw
2
.
– Clean and grease the wheel spindle.
Long-life grease ( p. 123)
– Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
2
.
Guideline
Screw, front wheel
spindle
M8 25 Nm (18.4 lbf ft)
–
Position wheel speed sensor
3
in the hole.
–
Mount and tighten screw
4
.
Guideline
Screw, wheel speed
sensor holder
M6 8 Nm (5.9 lbf ft)
– Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
– Take the motorcycle off the front lifting gear. ( p. 62)
– Remove the rear of the motorcycle from the lifting gear.
( p. 61)
– Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
5
.
Guideline
Screw, fork stub M8 15 Nm (11.1 lbf ft)
15.3 Removing the rear wheel
Preparatory work
– Raise the motorcycle with the rear lifting gear. ( p. 61)
S04164-10
Main work
–
Remove screw
1
.
To Next Page
Loading...
Need help?
General
