17 CLEANING, CARE 77
17.1 Cleaning the motorcycle
Note
Material damage Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
– Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
– Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance 60 cm (23.6 in)
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable regu-
lations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
401061-01
– Close off the exhaust system to keep water from entering.
– Remove loose dirt first with a soft jet of water.
– Spray very dirty parts with a normal, commercially available engine cleaner and
then brush off with a soft brush.
Motorcycle cleaner ( p. 89)
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always rinse the vehicle
with water first.
– After rinsing the motorcycle with a gentle spray of water, allow it to dry thoroughly.
– Remove the closure of the exhaust system.
– Empty the carburetor float chamber. ( p. 73)
Warning
Danger of accidents Moisture and dirt impair the brake system.
– Explain to your child that he or she must brake carefully several times to
dry out and remove dirt from the brake linings and the brake discs.
– After cleaning, let your child ride the vehicle a short distance until the engine
warms up and the brakes have dried due to careful application of the brakes.
Info
The heat produced causes water at inaccessible locations in the engine and
on the brake system to evaporate.
– Push back the protection caps on the handlebar controls to allow water to evapo-
rate.
– After the motorcycle has cooled off, lubricate all moving parts and bearings.
– Clean the chain. ( p. 46)
– Treat bare metal (except for brake discs and the exhaust system) with a corrosion
inhibitor.
Preserving materials for paints, metal and rubber ( p. 89)
– Treat all plastic parts and powder-coated parts with a mild cleaning and care prod-
uct.
Special cleaner for glossy and matte paint finishes, metal and plastic surfaces
( p. 89)
To Next Page
Loading...
Need help?
General
