1. Remove the split pin and tighten the adjusting nut.
Tightening torque
20 N⋅m
(2.0 kgf⋅m)
2. Make sure that one of the nut slots aligns with the
split pin hole.
3. Tighten the nut slightly if necessary when aligning
the nut slots with the split pin hole.
4. Replace the split pin.
(1) Adjusting nut (2) Split pin
2. Changing the transmission fluid
WARNING
To avoid serious injury or death:
• Oil can be hot and can burn. Allow the engine to
cool down sufficiently.
IMPORTANT :
• Do not operate the tractor immediately after
changing the transmission fluid.
Run the engine at medium speed for a few
minutes to prevent damage to the transmission.
Transmission fluid KUBOTA SUPER UDT 2
Transmission fluid capacity 11.3 L
1. To drain the used transmission fluid, remove the
drain plug at the bottom of the transmission case
and drain the transmission fluid completely into the
oil pan.
2. After draining the transmission fluid, reinstall the
drain plug.
3. Clean the transmission strainer.
4. Fill with new transmission fluid up to the upper
notch on the dipstick.
(See LUBRICANTS, FUEL AND COOLANT on
page 84 and Checking the transmission fluid level
on page 87)
5. After running the engine for a few minutes, stop it
and check the transmission fluid level again.
6. If the transmission fluid level is lower than the
prescribed level shown in the following figure, add it
to the prescribed level.
7. Properly dispose of used transmission fluid.
(1) Drain plug
(2) Oil inlet
(3) Dipstick
(A) Transmission fluid level is
acceptable within this range
PERIODIC SERVICE SERVICE EVERY 400 HOURS
To Next Page
Loading...
Need help?
General
