(1) Fan switch (A) On (press the first time)
(B) High (press the second time)
3. Air control vent
CAUTION
To avoid personal injury:
• Replace the water hoses every 2 years.
• Daily inspection
Have the tractor repaired immediately if any
of the following defects are discovered. Such
defects may cause burns or injury. Such defects
may also cause engine seizure or other serious
failure.
– Scratches, cracks, or swelling in water
hoses.
– Water leakage at water hose joints.
– Missing or damaged water hose protective
wrap or grommets.
– Loose mounting bolts and damaged
brackets.
• Do not touch the water hoses and the heater
with your hand. You may get burned.
• If the window fails to defrost in extreme
conditions or becomes cloudy when
dehumidifying the CAB, wipe off moisture with
a soft cloth.
• Do not block all the air nozzles of the air
conditioner. A problem could occur.
To obtain warm air inside the CAB, engine coolant has
to be hot. Run the tractor a little before operating the
heater.
Air nozzles adjustment
The air nozzles are located at the front top and rear
inside the CAB as shown in the figure.
The air nozzles can be fully opened or fully closed.
The air nozzles can be turned left or right depending
on the desired air directions on the windows or on the
operator. The air nozzles can be rotated (360 deg.) to
change the air directions.
(1) Air nozzle (A) Open
(B) Close
(C) Rotate
4. Operating the heater to adjust the
temperature
1. If you require warmer temperature , put the dial at
the position (A).
2. If you want to lower the temperature, turn the dial
from the position (B) to the position (A).
(1) Dial
(A) Lower temperature
(B) Raise temperature
BEACON (IF EQUIPPED)
1. Beacon light switch (if equipped)
1. To light the beacon, press the beacon-light-switch
where the yellow label is applied.
2. To stop the turning light (beacon), press the upper
part of the beacon-light-switch.
CAB OPERATION HEATER
To Next Page
Loading...
Need help?
General
