Kubota BX261D User Manual

(1) Grease fitting for the speed
control pedal
(2) Bonnet guide
(3) Rear link
Apply grease between stays.
(1) Bonnet lock
2. Checking the engine start system
WARNING
To avoid serious injury or death:
• Do not allow anyone near the tractor while
testing.
• If the tractor does not pass the test, do not
operate the tractor.
Preparation before testing
1. Sit on the operator's seat.
2. Set the parking brake and stop the engine.
3. Shift the range-gear-shift-lever to the neutral [N]
position.
4. Check whether the speed-control-pedal is in the
neutral position.
5. Shift the PTO-clutch-lever to the off
position.
Test of switch for the range gear shift lever
1. Make sure that the range-gear-shift-lever is set
except the neutral [N] position.
2. Turn the key to the start position.
3. Make sure that the engine does not crank.
4. If the engine cranks, consult your local KUBOTA
Dealer.
Test of switch for the speed control pedal
1. Make sure that the range-gear-shift-lever is set in
the neutral [N] position.
2. Depress the speed-control-pedal.
3. Turn the key to the start position.
4. Make sure that the engine does not crank.
5. If the engine cranks, consult your local KUBOTA
Dealer.
Test of switch for the PTO clutch lever
1. Make sure that the range-gear-shift-lever is set in
the neutral [N] position.
2. Make sure that the speed-control-pedal is set in the
neutral position.
3. Shift the PTO-clutch-lever to the on position.
4. Turn the key to the start position.
SERVICE EVERY 50 HOURS PERIODIC SERVICE
BX231D
91

Kubota BX261D Specifications

General

Brand	Kubota
Model	BX261D
Category	Tractor
Language	English