2. Detach the radiator screen, and then remove all the
foreign material.
NOTE :
• If the dust or chaff is accumulated in the
battery compartment, open the panel and
clean completely.
(1) Panel
(2) Knob
(3) Centre pillar
(4) Radiator screen
(A) Detach
7. Checking the brake pedal
1. Inspect the brake pedal for free travel, and smooth
operation.
2. Adjust the brake pedal if incorrect measurement is
found.
(See Adjusting the brake pedal on page 97)
8. Checking the gauges, the meters,
and the Easy Checker
™
1. Inspect the instrument panel for broken gauge(s),
meter(s), and Easy Checker
™
.
2. Replace the gauge(s), the meter(s), or the Easy
Checker
™
if they are broken.
9. Checking the headlights, hazard
lights, and so on
1. Inspect the lights such as the head light, hazard
light, and so on for broken bulbs and lenses.
2. Replace the lights such as the head light, hazard
light, and so on if they are broken.
10. Checking the seat belt and the
ROPS
1. Always check condition of the seat belt and the
hardware to attach the ROPS before operating the
tractor.
2. Replace the seat belt or the ROPS if it is damaged.
11. Checking and cleaning the
electrical wiring and the battery
cables
WARNING
To avoid serious injury or death:
• A loosened terminal or connector, or damaged
wire may affect the performance of the electrical
components or cause short circuits. Leakage
of electricity could result in a fire hazard,
a dead battery, or damage to the electrical
components.
• Replace the damaged wires or connections
promptly.
• If a fuse blows soon after replacement, do not
use the capacity larger than recommended or
bypass the fuse system.
• Many wiring connections are protected by
waterproof plugs. Plug and unplug these
connections carefully and make sure that they
are sealed correctly after assembly.
• Accumulation of dust, chaff, and deposits of
spilled fuel around the battery, electrical wiring,
engine, or exhaust system may cause fire
hazards.
Clean around the battery, electrical wiring,
engine or exhaust system before starting to
work.
• To avoid premature electrical malfunctions, do
not apply high pressure water directly to the
battery, the wiring, the connectors, the electrical
components, or the instrument panel.
Inspect the following check items regularly
• Check the wiring for chafed or cracked insulation.
• Check the wiring harness clamps. Replace them if
necessary.
DAILY CHECK PERIODIC SERVICE
To Next Page
Loading...
Need help?
General
