EasyManuals Logo

Kubota BX261D User Manual

Kubota BX261D
121 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #106 background imageLoading...
Page #106 background image
SERVICE EVERY 1000 HOURS
OR 1 YEAR
1. Replacing of the air cleaner
element
Replace the air cleaner element every 1000 hours or
every 1 year whichever comes faster.
(See Cleaning the air cleaner element on page 94)
SERVICE EVERY 1500 HOURS
1. Checking the injection pressure of
the fuel injection nozzle
Consult your local KUBOTA Dealer for checking the
injection pressure of the fuel-injection-nozzle.
SERVICE EVERY 2000 HOURS
OR 2 YEARS
1. Flushing the cooling system and
changing the coolant
WARNING
To avoid serious injury or death:
Do not remove the radiator cap while the
coolant is hot. When the coolant is cool, slowly
rotate the radiator cap to the first stop and allow
sufficient time for excess pressure to escape
before removing the radiator cap completely.
IMPORTANT :
Do not start the engine without coolant.
Use clean, fresh soft water and the antifreeze to
fill the radiator and the recovery tank.
When mixing the antifreeze with water,
the antifreeze mixing ratio is the following
percentage.
Antifreeze mixing ratio with water 50%
Securely tighten the radiator cap. If the radiator
cap is loose or improperly fitted, water may leak
out and the engine could overheat.
Be sure to flush the cooling system and to change
the coolant once every 2000 hours or every 2 years
whichever comes faster.
Coolant capacity (with
recovery tank)
BX231D 3.1 L
BX261D 3.3 L
1. Stop the engine and let it cool down.
2. To drain the coolant, open the radiator-drain-plug or
the engine-drain-plug and remove the radiator cap.
The radiator cap must be removed to completely
drain the coolant.
3. After all coolant is drained, close the drain plug.
4. Fill the radiator with clean soft water and the
cooling-system-cleaner.
5. Follow directions of the instruction of cooling-
system-cleaner.
6. After flushing the radiator, fill it with clean soft water
and the antifreeze until the coolant level is just
below the radiator cap.
7. Install the radiator cap securely.
8. Fill the recovery tank with coolant up to the [H]
mark on the recovery tank.
9. Start and operate the engine for few minutes.
10. Stop the engine and let it cool.
 PERIODIC SERVICE SERVICE EVERY 1000 HOURS OR 1 YEAR
102
BX231D

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota BX261D and is the answer not in the manual?

Kubota BX261D Specifications

General IconGeneral
BrandKubota
ModelBX261D
CategoryTractor
LanguageEnglish

Related product manuals