STV32 · STV36 · STV40, WSM CLUTCH
2-S4
4. CHECKING, DISASSEMBLING AND SERVICING
[1] CHECKING AND ADJUSTING
Checking Clutch Pedal Free Travel
A When checking, park the tractor on flat ground, apply the
parking brake, stop the engine and remove the key
1. Slightly depress the clutch pedal (1) and measure free travel
"L" at top of the clutch pedal.
2. If the measurement is not within the factory specification,
loosen the lock nut and adjust the clutch rod (2) length.
A After adjustment, be sure to check the operation of the
safety switch (3). The engine should not start if the clutch
pedal is not fully depressed. Refer to "Safety Switches"
(page 9-S16) in ELECTRICAL SYSTEM section for the
safety switch.
[2] PREPARATION
(1) Separating Engine from Clutch Housing
Clutch pedal free travel
"L" on top of clutch
pedal
Factory spec.
20 to 30 mm
0.78 to 1.18 in.
(1) Clutch Pedal (3) Safety Switch
(2) Clutch Rod L : Clutch Pedal Free Travel
0000007517E
A Follow the procedure from "Draining Transmission Fluid" (Page 1-S20) to "Separating the Engine from
Clutch Housing" (Page 1-S25) in ENGINE section.
0000007518E
To Next Page
Loading...
Need help?
General