Kubota WSM STV32 User Manual

STV32 · STV36 · STV40, WSM GENERAL
G-13
[2] CHECK POINTS OF INITIAL 50 HOURS
Changing Engine Oil
A Before changing oil, be sure to stop the engine.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom
of the engine and drain the oil completely.
4. Screw in the drain plug (1).
5. Fill new oil up to upper line on the dipstick (2).
A When using an oil of different manufacture or viscosity
from the previous one, remove all of the old oil.
A Never mix two different types of oil.
A Use the proper SAE Engine Oil according to ambient
temperatures.
A Refer to "LUBRICANTS, FUEL AND COOLANT". (See
page G-8.)
Engine oil Capacity
6.7 L
7.1 U.S.qts
5.9 lmp.qts
(1) Drain Plug (A) Oil level is acceptable within
(2) Dipstick this range.
(3) Oil Inlet Plug
0000007967E
KiSC issued 04, 2006 A

Kubota WSM STV32 Specifications

General

Brand	Kubota
Model	WSM STV32
Category	Tractor
Language	English