KYMCO PEOPLE S 125 Service Manual

17 . LIGHTS/INSTRUMENTS/SWITCHES
17-7
PEOPLE S 4T
INSPECTION
Measure the resistance between the fuel unit
wire terminals with the float at upper and
lower positions.
RESISTANCES Unit: Ω
Float
Color
Upper Lower
G～Y/W 5～10 85～105
The installation sequence is the reverse of
removal.
AUTO BYSTARTER
AUTO BYSTARTER INSPECTION
Remove the body cover. (
Ö
2)
Disconnect the auto bystarter wire connector.
Measure the resistance between the yellow
and green/black wire terminals.
Resistance: 15Ω max.
RESISTOR INSPECTION
Remove the front cover. (
Ö
2)
Disconnect the green/black and green wires
and measuring the resistance between the
wire terminals.
Resistance: 5Ω max.
If the needle remains at “∞”, it indicates that
the resistor is faulty and must be replaced.
• Install the fuel unit on the connect
position.
＊
Perform this operation when the engine
is cold.
＊
A
uto Bystarter Connecto
r
A
uto Bystarter Resisto
r

KYMCO PEOPLE S 125 Specifications

General

Displacement	124.6 cc
Front Suspension	Telescopic Fork
Cooling System	Air Cooled
Max Torque	10.4 Nm @ 6500 rpm
Transmission	CVT
Front Brake	Disc