XPort® Device Server User Guide 85
Table 11-1. Monitor Mode Commands
Command Command Name Function
AT
ARP Table Shows the unit’s ARP table entries.
co
Set IP address,
hostbits, gateway ,
and DNS server IP
Example:
co 192.168.0.10 8 192.168.0.1 10001 192.168.1.10
with
192.168.0.10 = IP address of the XPort module
8 = number of hostbits
192.168.0.1 = gateway IP address
10001 = port number of the XPort module
192.168.1.10 = IP address of the DNS Server
The XPort device server stores the setup and
performs a reset. It sends an X before the reset
if the command was
.
G0, G1, ....,Ge, Gf
Get configuration
from memory page
Gets a memory page of configuration information
from the device.
GC x.x.x.x
Get Configuration Gets configuration of unit with IP address x.x.x.x as
hex records (120 bytes).
GM
Get MAC address Shows the unit's 6-byte MAC address.
NC
Network Connection Shows the unit’s IP address, gateway, subnet
mask, and DNS server.
NS
Network Status Reports the network interfaces’ statuses. Includes
potentially negotiated parameters like speed/duplex
for Ethernet or BSSID, encryption, authentication
for wireless interfaces.
Ping Pings unit with IP address x.x.x.x to check device
status.
QU
Quit Exits diagnostics mode.
RS
Reset Resets the unit’s power.
S0, S1,...,Se, Sf
Set configuration to
memory page
Sets a memory page of configuration information
on the device.
SA
Scan Initiates a wireless scan if the wireless interface is
enabled. Reports any stations found, including
BSSID, SSID, and RSSI. If SA is followed by a
string, the string is used to filter SSIDs before
reporting. If the BSS does not broadcast its SSID,
only the BSSID and RSSI are returned.
SC x.x.x.x
Send Configuration Sets configuration of unit with IP address x.x.x.x
from hex records.
SS
Set Security record
Sets the Security record without the encryption key
and length parameters. The entire record must still
be written, but the encryption-specific bytes do not
To Next Page
Loading...
Need help?
General