To change the setting:
1 From the Configuration menu, navigate to Safe Mode.
2 Select On or Off to change the setting.
3 Select Submit.
4 POR the printer.
Demo Mode
The Demo Mode lets marketing personnel or merchandisers demonstrate the printer to potential customers by printing
the demo page.
Selections include Deactivate (default) and Activate. Select Deactivate to turn Demo Mode off; or select Activate to
turn Demo Mode on.
Factory Defaults
Warning—Potential Damage: This operation cannot be undone.
This setting enables a user to restore all of the device settings to either the network settings (on network models only)
or to the base device settings.
To print current menu settings:
Note: It is recommended that you first print the customer’s current settings by printing a copy of the Menu Settings
pages. Customer settings are available from the Ready prompt Diagnostics Menu settings are available in the
Diagnostics Menu, and Config Menu settings are available in the Config Menu.
1 Turn the printer off, or select Exit Config Menu.
2 At the Ready prompt, select Menus and press Select.
3 Select Reports, and press Select.
4 Select Menu Settings Page, and press Select.
5 Enter the Diagnostic Menu, select Reports, Menu Settings Page, and press Select.
6 Turn the printer off, or select Exit Diags.
7 Enter Configuration Menu, select Reports, Menu Settings Page, and press Select.
To reset factory defaults:
1 Select Reports from the Config Menu, and press Select.
2 Select Factory Defaults, and press Select
3 Select Restore Base (for locally attached printers) or Restore STD NET (if you have integrated network support).
Submitting Changes… appears on the operator panel, and then the printer PORs (restarts in Ready mode).
7527
Service menus
193
To Next Page
Loading...
Need help?
General
Weight and Dimensions
