When an event other than page count triggers this calibration, the count that monitors the maximum number of pages
printed will be reset. For example, if the user replaces an empty toner cartridge, the next time the printer is started, it
will sense the new cartridge and perform the automatic color adjustment, even though the page counter for Auto Color
Adj is fewer than required. The Auto Color Adj page counter is then reset.
Font Sharpening
Font Sharpening allows a user to set a text point-size value below the setting of the high-frequency screens used when
printing font data. This menu item affects only the PostScript, PCL 5, PCL XL, and PDF emulators.
Settings are in the range of 0–150 (24 is the default). For example, if the value is set to 24, then all fonts sized 24 points
or less use the high-frequency screens. To increase the value by 1, press the right arrow; to decrease the value by 1,
press the left arrow.
Exit Config
Press Select to exit the Configuration Menu. The printer performs a power-on reset and returns to normal mode.
Entering invalid engine mode
This mode is used if the machine has invalid code and needs the correct code loaded. After entering this mode, the
firmware code can be updated.
1 Turn off the printer.
2 Press and hold the 3, 4, and 6 buttons simultaneously.
3 Turn on the printer.
4 Release the buttons after 10 seconds.
Entering recovery mode
This mode will allow the printer to boot from a secondary set of instructions to allow a code flash to the printer. Code
can be flashed from a PC via USB.
1 Turn off the printer.
2 Press and hold the 7, 2, and 8 buttons simultaneously.
3 Turn on the printer.
4 Release the buttons after 10 seconds.
Accessing the Network SE menu
This menu contains settings for fine tuning the communication settings for the network interfaces and protocols.
1 Touch Select and Right.
2 Navigate to Networks/Ports > Standard Network > Std Network Setup.
3 Press and hold 6, 7, and 9 simultaneously.
7527
Service menus
197