Memory
6-3
Storing Resources on Flash Memory or Disk
Complete the following steps to download resources to flash memory or disk using the
printer operator panel, MarkVision or a PJL command.
1 Set the download target to flash memory or disk.
Resource Data Collection mode is enabled to the device selected.
2 Download the resources to flash memory or disk using PCL emulation or
PostScript emulation.
• PCL emulation collects and stores the currently defined font, macro, or sym-
bol set information in printer RAM memory. These resources are written to
flash memory or disk when Resource Data Collection is disabled (see step 3).
Stored resources are also copied to flash memory or disk when a printer lan-
guage switch occurs.
• PostScript emulation writes Type 1 fonts or other resources to flash memory
or disk after successfully parsing a definefont operator.
3 Set Download Target to RAM.
Resource Data Collection mode is disabled.
Viewing the Contents of Flash Memory and Disk
There are three ways to view the contents of flash memory and disk:
• Send the PJL LPRINTDIRECTORY command (see “LPRINT Commands
(Information Pages)” on page 3-76).
• Select Print Directory from the printer operator panel menus.
• Use the MarkVision utility.
The directory lists the storage device (flash or disk), the names of the files, and the file
size. See page 6-4 for a sample directory.
To Next Page
Loading...
Need help?
General