UMX-TPS-TX100 series – User's Manual 89
View Serial Number
The device responds its 8-digit serial number.
Command and Response #serialnumber
ȩ {S}
Ȩ (SN:<
Example
ȩ {s}
Ȩ (SN:5A004254)
The serial number structure can be found in the About the Serial Number section.
View Installed Board
Shows the hardware name and revision of the installed cards.
Command and Response
ȩ {IS}
Ȩ MB_DESC
Ȩ
Example
ȩ {is}
Ȩ
Ȩ
The device reports its motherboard (slot 0).
View Firmware for All Controllers
Command and Response
ȩ {FC}
Ȩ (CF·<DESC
Ȩ (CF·<DESC
Ȩ …
Ȩ
Example
ȩ {fc}
Ȩ (CF UMX-TPS-TX140K 1.5.0b1 r53)
Ȩ (CF END)
The device has one control panel.
Internal voltages and measured temperature values are shown.
Command and Response #status
ȩ {ST}
Ȩ (ST·<DESC
Example
ȩ {st}
Ȩ
Restart the Device
The device can be restarted without unplugging power.
Command and Response #reboot #restart
ȩ {RST}
Ȩ
Example
ȩ {rst}
Ȩ
The device reboots; no response is sent in this case.
Restore Factory Default Settings
Settings can be reset to factory default values as follows:
Command and Response
ȩ
Ȩ
Example
ȩ {factory=all}
Ȩ
All settings and parameters are reset to factory default, see the table in the Factory Default Settings section.
#factory
To Next Page
Loading...
Need help?
General
