Starting/switching off the engine – for crane operation
10.3 Switching off the engine
10 - 22 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
10.3.2 In emergencies, with the emergency stop switches
Four emergency stop switches are provided
for emergencies:
• Press an emergency stop switch (1), (2) or (3).
The switch latches.
The engine shuts down. If the engine for
driving was on, it will stop as well.
H
If an air intake inhibitor is present, then it will be triggered – this also applies
to the engine for driving.
Resetting the
emergency stop
switch
You can restart the engine only after you have reset the emergency stop
switch.
• Switch off the ignition.
• Turn the actuated emergency stop switch until it disengages again.
If air intake inhibitors are fitted, they must be released;
à Releasing the air intake inhibitor, p. 10 - 23,
à Releasing the air intake inhibitor, p. 4 - 25.
G
Risk of overloading if used improperly!
Use the emergency stop switches only in an emergency, i.e. if the crane
functions no longer respond to the control levers.
Stopping crane movements suddenly may cause the truck crane to become
overloaded under unfavourable conditions.
1 On the carrier
2 On the hand-held control
3 In the crane cab
To Next Page
Loading...
Need help?
General
