Rigging work
12.4 Connecting/disconnecting the hand-held control
Operating Manual GMK6300L 3 112 xxx en 12 - 21
xx.xx.xxxx
12.4 Connecting/disconnecting the hand-held control
H
Switch off the engine for driving and crane operation. Pulling a bridging
plug will make the engines go out, but this action is only designed for
emergencies.
The ignition can be switched on or off.
Connecting the hand-held control
• Open the cap (2) and pull the bridging
plug (3) out of the socket (1).
• Insert the plug (4) into the socket (1) and
secure it with the cap (2).
• After approx. 20 seconds, the lamps (5)
and (6) light up – the ignition is now
switched on.
There is a malfunction if the lamp (5) does
not light up or flash;
à p. 14 - 24.
Removing the hand-held control
• Open the cap (2).
• Pull the plug (4) out of the socket (1) – the
lamps (5) and (6) go out.
• Insert the bridging plug (3) into the socket (1)
and secure it with the cap (2).
The ignition is switched off, unless it is
switched on at an ignition lock.
G
Danger due to unauthorised use!
Always stow the hand-held control in the driver's cab or in the crane cab
before you leave the crane, and lock the doors.
This way you can prevent unauthorised persons starting the engine.
To Next Page
Loading...
Need help?
General
