Crane operation
11.2 Operation of the rated capacity limiter
11 - 40 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
11.2.8 RCL override
There are two types of RCL override, depending on the version.
RCL override – symbol (A)
The operating elements (1), (2) and (4) have
not been assigned functions.
• Insert the key into the key-operated
switch (3).
• Turn the key to the right and hold it in this
position.
The display (5) shows the error message 8022.
Cancelling the override
• Let go of the key (3).
• Remove the key.
• Press button Y once; the error message is
acknowledged.
If additional equipment is used, the status
display (1) indicates this in the same way as
the RCL display in the crane cab:
G
Risk of accidents due to overridden or faulty RCL!
It is not permitted to work with an overridden or faulty RCL!
Set down the load immediately and stop operating the crane if the RCL is
faulty!
You may override the RCL only if it becomes absolutely necessary to do so
in the event of an emergency. This is to put the truck crane into a safe state
in the event of a malfunction. In this case, do not perform any movements
that would increase the load moment.
Green: 0 – 90%
Yellow: approx. 90 – 100%
Red: greater than 100%
S
Risk of accidents due to unintentional override!
The key must not remain in the key-operated switch while the crane is
operating!
This prevents the RCL from overriding unintentionally.
To Next Page
Loading...
Need help?
General
