Rigging work
12.8 Rigging work on the main boom
12 - 92 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
12.8.4 Reeving and unreeving the hoist rope
You must reeve a certain number of rope lines, depending on the required
load bearing capacity. Four reeved rope lines correspond, for example,
to 4-fall reeving.
Possible reevings and the corresponding lifting capacities;
à p. 12 - 97.
Rope end fitting To reeve and unreeve the hoisting rope, you must remove the rope end
fitting.
After reeving you must reattach the rope end fitting.
Removing the rope end fitting
• Pull the pin (2) and remove the fork
element (1).
• Slide the holder (3) back and remove it from
the hoist rope (4).
Reattaching the rope end fitting
• Insert the holder (3) and slide it onto the
hoist rope as far as it will go (4).
• Fasten the fork (1) using the pin (2).
• Secure the pin using the linchpin.
To Next Page
Loading...
Need help?
General
