Mercury MerCruiser MIE 8.2L MPI User Manual

DRIVE SHAFT / PROPELLER SHAFT MODELS
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 8F-11
7. Replace any damaged parts.
75280
a
b
c
c
e
f
g
h
j
i
d
454/502 Mag MPI Version
75281
a
b
c
e
f
g
h
i
d
7.4L MPI Version
a-Snap Ring - Input Shaft
b-Snap Ring - Ball Bearing
c-Ball Bearing
d-Bearing Support
e-Grease Fitting
f-Oil Seal
g-Input Shaft
h-Grease Fitting
i-Plug - Input Shaft
j-Spacer
Reassembly
1. If removed, install new plug in end of input shaft.
2. Apply Quicksilver Loctite 27131 to outer diameter of new oil seal.
3. Press oil seal into bearing support. Lip of seal faces away from ball bearing.
4. Apply Loctite 290 to outer diameter of ball bearing and inner diameter of bearing
support.
5. Install bearing (with sealed side toward snap ring) by using a press. After installation,
wipe up excessive Loctite. Install snap ring.
6. Apply Loctite 290 to outer diameter of input shaft (bearing area) and inside diameter of
bearing race.
Downloaded from https://needmanual.com/!
Index

Mercury MerCruiser MIE 8.2L MPI Specifications

General

Brand	Mercury
Model	MerCruiser MIE 8.2L MPI
Category	Engine
Language	English