WALTER V-DRIVE TRANSMISSION SERVICE MANUAL NUMBER 23
Page 8E-4 90-861326--1 MARCH 1999
Filling Transmission
1. Remove dipstick from top cover. Fill transmission with fluid, through dipstick hole, to
bring up to full mark.
75192
a
a-Dipstick
IMPORTANT: To accurately check fluid level, run engine for 2 minutes immediately
prior to checking level.
Removal
1. Refer to the “Draining Procedures” in the maintenance section to drain the cooling sys-
tem.
2. Disconnect the propshaft coupler from the output shaft flange of the transmission.
75646
a
b
a-Nuts (4)
b-Propshaft Coupler
3. Drain transmission fluid.
4. Remove the water cooling hoses from the transmission.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General