STARTING SYSTEM SERVICE MANUAL NUMBER 23
Page 4A-26 90-861326--1 MARCH 1999
Brushes and Brush Holder
INSPECTION
Replace brushes and holder when brush leads are touching guide.
Make sure brushes move freely in guides.
72069
b
a
a-Brush Leads
b-Guide
INSTALLATION
1. Push each brush up into its guide, use a 3 inch (75 mm) piece of coat hanger wire or
similar stiff wire to retain the spring while installing armature, as shown.
b
c
a
d
a-Brush
b-Guide
c-Brush Spring
d-3 Inch (75 mm) Piece Of Coat Hanger Or Stiff Wire
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General