MAINTENANCE SERVICE MANUAL NUMBER 23
Page 1B-12 90-861326--1 MARCH 1999
Transmissions
NOTICE
Unit Of Measurement: U.S. Quarts (Liters)
All capacities are approximate fluid measures.
MAKE AND MODEL
CAPACITY
QUARTS
(LITERS)
1
FLUID TYPE
Velvet Drive 72C In-Line 1.5 (1.3)
5000A
Dexron III Automatic
5000V
.
Transmission Fluid
Hurth 630V 4.25 (4.0)
Walter V-Drive Model RV-36 .75 (.71)
SAE 30 Heavy Duty
Motor
Exxon Spartan
EP-68 Gear Oil
APG-80 Gear Oil
1
Always use dipstick to determine exact quantity of fluid required.
Sterndrive Units
NOTICE
Unit Of Measurement: U.S. Fluid Ounces (Milliliters)
All capacities are approximate fluid measures.
Model Bravo One Bravo Two
Bravo
Three
Blackhawk
Drive Unit Oil
Capacity (With
Gear Lube
Monitor)
88 (2603) 104 (3076) 96 (2839) 80 (2365)
20-Hour Break-In Period
IMPORTANT: The first 20 hours of operation is the engine break-in period. Correct
break-in is essential to obtain minimum oil consumption and maximum engine
performance. During this break-in period, the following rules must be observed:
• Do not operate below 1500 rpm for extended periods of time for first 10 hours. Shift into
gear as soon as possible after starting and advance throttle above 1500 rpm if condi-
tions permit safe operation.
• Do not operate at one speed consistently for extended periods.
• Do not exceed 3/4 throttle during first 10 hours. During next 10 hours, occasional
operation at full throttle is permissible (5 minutes at a time maximum).
• Avoid full throttle acceleration from IDLE speed.
• Do not operate at full throttle until engine reaches normal operating temperature.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General