STARTING SYSTEM
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 4A-33
Installation
IMPORTANT: Install special mounting shim (if equipped) between starter motor and
engine block.
1. Place starter motor in position and install mounting bolts. Torque bolts to 50 lb-ft (68 Nm).
2. Connect yellow/red wire to terminal S of solenoid. Connect orange wire and red wire to
fuse terminal. Connect battery cable to large terminal of solenoid. Tighten fasteners
securely. Coat terminals with Quicksilver Liquid Neoprene. Install battery cable boot, if
so equipped.
72637
.
0
0
d
c
a
b
a-Positive (+) Battery Cable
b-Rubber Boot
c-Orange Wire and Red Wire
d-Yellow/Red Wire
3. Connect battery cables to battery in the following order. Connect positive (+) cable to
positive (+) battery terminal and tighten cable clamp. Then connect negative (–) cable
to negative (–) terminal and tighten clamp.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General