454 CID (7.4L) / 502 CID (8.2L)
SERVICE MANUAL NUMBER 23
Page 3A-49
90-861326--1 MARCH 1999
Oil Pan
Removal
1. Drain crankcase oil.
2. Remove dipstick and tube, or tubes, if equipped with two. Note shape of port and star-
board tubes as shown following to aid in reassembly.
IMPORTANT: DO NOT move or disturb the orientation of fitting on bottom of pan or
incorrect oil level readings may be obtained.
71308
c
b
a
a-Factory Positioned Fitting For Tubes (Do Not Move)
b-Port Tube
c-Starboard Tube
3. Remove oil pan.
Installation
1. Clean sealing surfaces of engine block and oil pan.
2. Apply a small amount of Quicksilver RTV Sealer to joints of rear seal retainer and joints
of front cover.
IMPORTANT: Quicksilver RTV Sealer sets up in about 15 minutes. Be sure to com-
plete assembly promptly.
75496
a
b
a-Joints Of Rear Seal Retainer
b-Joints Of Front Cover
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General