MULTI-PORT FUEL INJECTION DISASSEMBLY AND REASSEMBLY
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 5C-47
Map Sensor
NOTICE
Refer to “Precautions” in this section, BEFORE proceeding.
1. Relieve fuel pressure from the fuel rail as previously described.
2. Disconnect the fuel line from the fuel rail.
3. Remove the plenum and fuel rail assembly as previously described.
4. Disconnect the electrical connector at the injector harness.
5. Remove the screws, nut, MAP sensor retainer clip and stud from the fuel rail.
6. Remove the map sensor from the intake manifold.
75615
a
b
a-MAP Sensor
b-Intake Manifold
CLEANING AND INSPECTION
1. Clean off any foreign matter with a dry cloth.
2. Inspect for any obvious signs of physical damage to the sensor.
3. Inspect seal for damage.
INSTALLATION
1. Lubricate the seal on the MAP sensor.
2. Install the MAP sensor in the intake manifold.
3. Install the fuel rail, plenum and associated parts as previously described.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General