COLLECTORS
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 7D-11
Maintenance
1. Air Intake Filter (32-17272) must be checked once each year. If filter is clogged or
partially clogged, replace. The filter pad is glued in, and may be removed with a
needle-nose pliers. Clean surface in casting, apply a single dot of Quicksilver Sound
Blanket Glue to center of casting, and install new filter. Be careful not to coat filter or clog
air intake holes with adhesive.
72534
a
b
c
d
e
f
g
h
i
j
k
ce
a-Mode Switch
b-Keyway - Install In DOWN Position
c-BROWN Wire To Terminal 3 - Activates Compressor
d-PURPLE Wire - 12 Volt; Connect To 12 Volt Source In Control Panel Area
e-GRAY Wire To Terminal 1 - Activates Solenoid
f-Air Pump
g-Solenoid
h-Check Valve
i-Relief Valve - 30 PSI
j-2 Ft. (610 mm) Ground Wire - Connect To Terminal - Must Be Grounded To
Engine
k-Air Intake Filter
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General