MULTI-PORT FUEL INJECTION DISASSEMBLY AND REASSEMBLY SERVICE MANUAL NUMBER 23
Page 5C-30 90-861326--1 MARCH 1999
INSTALLATION
1. Install IAT sensor in plenum. Tighten 2-1/2 turns maximum.
72802
a
b
a-Plenum
b-Intake Air Temperature (IAT) Sensor
2. Install plenum, throttle body, throttle cable and flame arrestor as outlined in “Plenum”.
3. Connect electrical connector to IAT sensor.
Idle Air Control (IAC) Valve
NOTICE
Refer to “Precautions” in this section, BEFORE proceeding.
REMOVAL
1. Remove flame arrestor, throttle cable and throttle body as outlined in “Throttle Body”.
2. Disconnect electrical connector from Idle Air Control (IAC) valve.
72800
a
b
c
d
a-Throttle Body
b-Idle Air Control (IAC) Valve
c-O-Ring
d-Screws
3. Remove IAC valve from throttle body.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General