MULTI-PORT FUEL INJECTION DISASSEMBLY AND REASSEMBLY
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 5C-21
CLEANING AND INSPECTION
Inspect fuel injectors for damage; replace if necessary.
INSTALLATION
IMPORTANT: When replacing injectors, be certain to replace with the identical part
and part number. Other injectors may have the same appearance, yet have a different
part number and be calibrated for a different flow rate. If installed, the wrong injector
would cause performance difficulty or damage to the ECM.
1. Install new O-rings on fuel injectors. Lubricate O-rings using a water/soap solution.
75741
76078
a
b
a
b
MEFI-1 and MEFI-2 MEFI-3
a-Fuel Injector
b-O-Ring
2. Install fuel injectors as outlined in “Fuel Rail” and “Intake Manifold”.
3. Install fuel rail, plenum, throttle body and flame arrestor as outlined in this section.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General