MULTI-PORT FUEL INJECTION DISASSEMBLY AND REASSEMBLY
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 5C-43
INSTALLATION
1. Place new gaskets on the manifold.
2. Place plenum over the manifold and install the screws. Torque screws to 30 lb-ft
(40 Nm).
75669
d
a
b
c
a-Screw (8)
b-Plenum
c-Gasket
d-Intake Manifold
3. Install the intake air temperature (IAT) sensor in the plenum.
4. Place the adapter gasket over the studs on the plenum.
5. Install the adapter and throttle body on the plenum. Install the nuts and torque to 75 lb-in.
(8.5 Nm).
75727
b
a
c
d
a-Plenum
b-Adapter Gasket
c-Throttle Body
d-Nut (3)
6. Install the flame arrestor and tighten the hose clamp securely.
7. Connect the throttle cable to the throttle lever.
8. Install the engine covers.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General