Mercury MerCruiser MIE 8.2L MPI User Manual

SERVICE MANUAL NUMBER 23
FUEL INJECTION SYSTEM TROUBLESHOOTING
Page 5D-9
90-861326--1 MARCH 1999
Hard Start Symptom (Continued)
9
1. Check for a ECT sensor shifted in
value.
2. With engine completely cool, mea-
sure the resistance of the ECT sen-
sor.
3. Refer to the Engine Coolant Tem-
perature Sensor Temperature -vs-
Resistance value table on the facing
page of DTC 14 in the “Trouble Code
Diagnostics” section. Compare the
approximate temperature of the
ECT sensor to an accurate reading
of ambient air temperature.
Are the readings within the specified
value?
10° F
(-12° C)
Go to Step
14
Go to Step 13
10
1. Check ECT sensor for being shifted
in value.
2. With the engine completely cool,
compare the ECT sensor tempera-
ture with an accurate reading of
ambient air temperature.
Are the temperatures within the
specified value of each other?
10° F
(-12° C)
Go to Step
11
Go to Step 13
11
1. Using a scan tool, display ECT sen-
sor temperature and note value.
2. Check resistance of ECT sensor.
3. Go to Engine Coolant Temperature
Sensor Temperature -vs- Resis-
tance value table on the facing page
of DTC 14 in the
Diagnostics sec-
tion.
Is resistance value of ECT sensor near
the resistance of the value noted?
-
Go to Step
14
Go to Step 12
12
Locate and repair high resistance or
poor connection in the ECT signal
circuit or the ECT sensor ground.
Is action complete?
-
Go to OBD
System
Check
-
13
Replace the ECT sensor.
Is action complete?
-
Go to OBD
System
Check
-
14
1. Check for intermittent opens or
shorts to ground in the MAP sensor
circuits.
2. If a problem is found, repair as nec-
essary.
Was a problem found?
-
Go to OBD
System
Check
Go to Step 15
Downloaded from https://needmanual.com/!
Index

Mercury MerCruiser MIE 8.2L MPI Specifications

General

Brand	Mercury
Model	MerCruiser MIE 8.2L MPI
Category	Engine
Language	English