SEAWATER COOLED MODELS SERVICE MANUAL NUMBER 23
Page 6A-14 90-861326--1 MARCH 1999
2. Press hub off shaft with Universal Puller Plate and an arbor press.
72648
a
a-Universal Puller Plate
3. Puncture front oil seal with a tool and pry from bearing housing.
72649
4. Remove snap ring from bearing housing bore and press shaft and bearings out pulley
end of housing. Bearings have a slip fit in housing; do not use excessive force.
72657
72658
a
a
a-Snap Ring
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General