Metrix HI 803 User Manual

Doc# 0296-0018 • REV R (July 2017) Page 11 of 61
CHAPTER 2 - SPECIFICATIONS
A Brief Descripon of Chapter 2
Chapter 2 lists the specicaons for the HI 803 TTS. Specicaons are listed for the standard instrument
and for oponal equipment. The specicaons listed are designed to assist in the installaon, operaon
and troubleshoong of the instrument. All service personnel should be familiar with this secon before
aempng an installaon or repair of this instrument.
Specicaons for the HI-803 TTS
Display • High Contrast, Wide Viewing Angle
• Displays 5 x 7 dots plus cursor
• 20 characters x 4 lines
• Backlit Screen
Calibraon Traceable to NIST standard at 100 Hz from 2 to 5 g’s
Measurement • Acceleraon: 10 Hz to 2k Hz ± .3 dB
Uncertainty 2kHz to 10k Hz ± 1 dB
• Velocity: 10 Hz to 500 Hz ± .3 dB
500 Hz to 2kHz ± .5 dB
• Displacement: 20 Hz to 150 Hz ± .3 dB
150 Hz to 200 Hz ± .5 dB
• Triax: 30 Hz to 200 Hz ± .3 dB
Frequency Readout Accuracy 3 Hz to 10 kHz: .001% +- 1 count
Amplitude Range
• Maximum Acceleraon 10 g (100 m/sec2), PK
• Maximum Velocity 10 in/sec (254 mm/sec), PK
• Maximum Displacement 100 mils (2.54 mm), Pk-PK
• Generates the peak output acceleraons at the frequency ranges and loads as
follows:
Frequency
Range
0-100
Grams
100-240
Grams
250-500
Grams
500-750
Grams
10-100 Hz 10 g 4 g 2 g 1 g
100-1000 Hz 7 g 4 g 2 g 1 g
1-2 kHz 3 g 1.5 g 1 g n/a
1-10 kHz 3 g 1.5 g n/a n/a
NOTE: 1. Limited at lower frequencies to 0.1 inch (2.54mm) PK-PK displacement.
2. Care should be taken when mounng the test transducer and its support brackets to
reduce the possibility of resonance and decoupling (an-resonance).
3. For maximum output, baeries should be fully charged. Preferably, the TTS should be
powered by an external AC power source.

Metrix HI 803 Specifications

General

Brand	Metrix
Model	HI 803
Category	Test Equipment
Language	English