Metrix HI 803 User Manual

Doc# 0296-0018 • REV R (July 2017) Page 19 of 61
FIG. 3-11 INSTALLATION OF MOUNTING BRACKET FOR AXIS A & B
Step 2. While holding the reference accelerometer steady with the spanner wrench, place the mounng
bracket (Prt. #0205- 0043-01) over the top of the reference accelerometer.
WARNING ALWAYS USE THE SPANNER WRENCH WHEN INSTALLING, REMOVING OR ADJUSTING THE
TRANSDUCERS OR MOUNTING BRACKET ON THE REFERENCE ACCELEROMETER.
Step 3. While sll holding the spanner wrench in place, use the allen wrench provided with the bracket
kit to screw the mounng bracket socket head screw into the reference accelerometer. (See Fig. 3-11)
Tighten the screw so that the bracket is snug against the reference accelerometer. If you want use a
torque wrench and torque to 18 inch pounds. Do not over torque the mounng screw. Overghtening
the mounng screw can cause bad readings.
Step 4. Install the connecng cable (Prt. # 0214-0088-01) between the Transducer under test (TUT) and
the input connector on the top panel. (See Fig. 3-12 & 3-13)
Triaxial Mounting Bracket
Mounting Bracket Screw
Spanner Wrench
Prt. #0228-072-01
Reference Accelerometer

Metrix HI 803 Specifications

General

Brand	Metrix
Model	HI 803
Category	Test Equipment
Language	English