Name: Metrix HI 803
Brand: Metrix
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Doc# 0296-0018 • REV R (July 2017) Page 44 of 61

Baery Check Mode

Step 7. Make sure of the following:

• The + voltage must be greater than the - voltage. This is due to the higher + voltage con-

sumpon.

• Both the + voltage and - voltage must be => 8.0. If they are not, plug in a power cord con-

nected to a 110 VAC, single phase, 50/60 Hz outlet. For the DI803-220VAC model plug into a

230 VAC, 50/60 Hz, single phase outlet.

• You can connue to operate the TTS while the baer- ies are being charged.

• The Memory status is the boom line beginning with MEM. The rst three digits are the

number of readings currently stored in memory. The next four digits are the total number of

readings that were available. Subtract the rst three digits from the next four digits to deter

mine how many readings can sll be stored in memory.

Setup Mode

Step 8. Press the MODE buon to get to the SETUP MODE screen.

Step 9. The SETUP MODE has three (3) displays as follows:

FIG. 5-3 SETUP MODE SCREEN #1

FIG. 5-4 SETUP MODE SCREEN #2

FIG. 5-5 SETUP MODE SCREEN #3

NOTE: The arrows in the upper right corner indicate the direcon to scroll when using the Up Arrow

or the Down Arrow buons.

Questions and Answers:

Need help?

Do you have a question about the Metrix HI 803 and is the answer not in the manual?

Metrix HI 803 Specifications

General