Miele DG 408 Series User Manual

Technical Information
35
DG 408x Steam Ovens
Figure 040-5: Steam Generator Temperature Regulator and Temperature Limiter
4.4 Removing the Steam Duct and Seal
1. Open the door.
2. Remove the steam generator.
3. Remove the insert from the steam generator housing.
4. Remove the bottom cover from the housing by gently pulling the cover from
the assembly while using a screwdriver to release the locking tabs, as
shown in Figure 040-4.
5. Remove the two steam duct retaining screws (T10s). See Figure 040-6, Item 1.
Figure 040-6: Steam Duct Retaining Screws
6. Remove the steam duct and seal.
Note:
When re-installing the seal,
make sure that the notch is
positioned as shown in
Figure 040-6, Item 2.

Miele DG 408 Series Specifications

General

Installation Type	Built-in
Control Type	Electronic
Energy efficiency class	A
Display	Yes
Power consumption	3.6 kW
Color	Stainless steel

Summary

Safety and General Information

Technical Data and Model Specifications

Overview of technical data and comparative model specifications.

Appliance Components and Layouts

Component Overviews and Electrical Diagrams

Diagrams and lists for appliance components and electrical parts.

Casing, Door, Cavity, and Water Systems

Casing, Airflow, and Door Operations

Information on appliance casing, air/vapor ducting, and door service.

Oven Cavity, Floor Heater, and Water Tank

Details on oven cavity components, floor heater, and water tank functions.

Electronics, Faults, and Service Procedures

Fascia, Electronics, and Fault Code Troubleshooting

Fascia panel, electronic overview, and common fault code resolutions.

Service Modes, Programming, and Technical Bulletins

Guidance on service modes, programming, and specific technical bulletins.