Miele DG 408 Series User Manual

Technical Information
53
DG 408x Steam Ovens
6. Disconnect the ribbon cable connecting the selection electronic to the
control electronic.
7. Take off the fascia panel.
Note:
The fascia panel is firmly attached to the selection electronic and can only
be replaced as a complete assembly.
4.4 Removing the Control Electronic (DG 4082)
1. Uninstall the appliance. See Section 010-4.1.
2. Remove the fascia panel. See Section 060-4.4.
3. Disconnect all control electronic connections (two wiring harnesses and
one ground wire).
4. Unclip and remove the control electronic from its mounting bracket. See
Figure 060-7.
Figure 060-7: Removing the Control Electronic (DG 4082)
4.5 Removing the Selection Electronic
Note:
The fascia panel is firmly attached to the selection electronic and can only
be replaced as a complete assembly.
1. Remove the fascia panel. See Section 060-4.3.
2. Install a new fascia panel/selection electronic assembly.

Miele DG 408 Series Specifications

General

Installation Type	Built-in
Control Type	Electronic
Energy efficiency class	A
Display	Yes
Power consumption	3.6 kW
Color	Stainless steel

Summary

Safety and General Information

Technical Data and Model Specifications

Overview of technical data and comparative model specifications.

Appliance Components and Layouts

Component Overviews and Electrical Diagrams

Diagrams and lists for appliance components and electrical parts.

Casing, Door, Cavity, and Water Systems

Casing, Airflow, and Door Operations

Information on appliance casing, air/vapor ducting, and door service.

Oven Cavity, Floor Heater, and Water Tank

Details on oven cavity components, floor heater, and water tank functions.

Electronics, Faults, and Service Procedures

Fascia, Electronics, and Fault Code Troubleshooting

Fascia panel, electronic overview, and common fault code resolutions.

Service Modes, Programming, and Technical Bulletins

Guidance on service modes, programming, and specific technical bulletins.