AS3000™ Service Manual 0070-10-0683 5 - 1
5.0
Calibration
5.1 Introduction
This section provides detailed information required to properly test and calibrate the
AS3000. Calibration consists of making mechanical and electrical adjustments with the
proper test equipment. The instrument should be tested and calibrated after repairs have
been completed or at regular intervals as part of a periodic maintenance procedure.
NOTE: Both calibration and a functional test must be performed to
verify complete and proper operation.
NOTE: Calibration is conducted in normal operating mode and in
Service Diagnostic mode.
Ensure that all testing materials, including drive gas, breathing circuits, test fixtures, tools and
documents are available and current, calibrated and in good working order prior to
beginning.
Testing and programming requires utilizing internal service software. A password is required
to enter these screens. This password is provided during biomedical technician training.
To Next Page
Loading...
Need help?
General
