Playinga Tape
!1
_Important:
_>Important:
Now that your VCR is connected and properly set up, and you
know how to view a picture coming from your VCR, it's time to
play a tape. This section describes:
• Playing back a tape, and
• Using basic playback controls.
Playingbacka tape
Beforeyoubegin,youneedto know:
• how to view the picture coming from your VCR (page 23).
O To play a tape, load a pre-recorded cassette.
Press the PLAY button either on the front panel or on the
remote control.
The VCR will automatically play the tape at the correct speed.
When the VCR reac:hes the end of the tape, it will automatically
rewind the tape and stop.
Playing a tape is also an Active A/V Network Feature. (For more
information, please see page 62.)
Usingbasicplaybackcontrols
rewindingatape
Press the REW button on the remote control or turn the shuttle
ring on the front panel to the left.
If the tape is stopped, you will begin rewinding. If the tape is
playing, you will be[on "reverse speed search."
If you press the POWER button while the tape is rewinding, the
VCR will turn OFF when the beginning of the tape is reached.
fastforwarding atape
Press the FF button on the remote contro]i or turn the shuttle ring
on the front panel to the right.
If the tape is stopped, you will1begin fast tbrward. If the tape is
playing, you will begin "forward speed search."
pausinga tape
Press the PAUSE button on the front panel or on the remote
control to freeze the picture on the screen.
If you leave the VCR in pause for 5 minutes, the VCR will1 auto-
matically stop to prevent damage to the tap._.
25
To Next Page
Loading...
Need help?
General
