Modification mode
[12]-20
3. Determining the block modification range (end point)
* Using Jog , , determine
the end point position.
* Press .
When the end point is determined, the
presser will automatically return to the
start point. Take care when the needle
is lowered, etc.
4. Setting the movement method and stitch length
* Set the movement method.
Press Prior/Subsequent Data
Change .
* Set the stitch length.
(Set to 3.0mm for this example.)
* Press .
5. Determining the movement amount
* Using the arrow keys, determine the
movement amount.(Move to the
position (point D').)
* Press .
(The block position will be modified.)
The work holder will move. (The work
holder will return to the start point of the
section being modified; in this case the
start point (A point) of the broken line
input.) Take care when the needle is
lowered, etc.
To Next Page
Loading...
Need help?
General
