Reading, writing and erasing data (internal memory)
[6]-2
2. Setting the pattern name and number
* Set the pattern name and number.
(The default pattern name and number
are set.)
To change the pattern name,
press , and to change
the number press .
Highlight the key, and then change the
setting.
When the key is pressed,
one of the alphanumeric characters
from the right can be deleted from the
pattern name or number.
3. Starting writing
* Press .
* If the same number as the data
number to be written is found in the
internal memory, a message prompting
whether to overwrite the same number
will appear.
If is pressed at this time,
the Write screen will reappear without
overwriting the data.
If the data can be overwritten,
press .
* After the message indicating writing in
progress appears, the Standard
screen will reappear.
Memo When is pushed,
empty capacity of an internal
memory is seen.
To Next Page
Loading...
Need help?
General
