talkgroup. See Secure Operations on page
100 for more information.
Selecting a Talkgroup
1
or to Tgrp and press the Menu Select button
directly below Tgrp.
The display shows the last Talkgroup that was
selected and stored.
2 Perform one of the following actions:
•
or to Pset for the preset preprogrammed
Talkgroup.
• or to the required Talkgroup.
3
Press the Menu Select button directly below Sel
to save the currently selected Talkgroup and
return to the Home screen.
If the encryption key associated to the new
Talkgroup is erased, you hear a momentary key
fail tone and the display shows Key fail.
If the encryption key that is associated to the new
Talkgroup is not allowed, you hear a momentary
key fail tone and the display shows Illegal key.
4
Press to return to the Home screen.
Sending a Status Call
This feature allows you to send data calls to the
dispatcher about a predefined status.
Each status can have up to a 14-character name. A
maximum of eight status conditions is possible.
Note:
The radio automatically exits the feature, if the
feature inactivity timer is enabled, when the
radio is left idle and the timer expires. You will
hear the Menu Inactive Exit Tone upon feature
exit.
1 Perform one of the following actions:
• Press the preprogrammed Status button.
•
or to Sts and press the Menu Select button
directly below Sts.
The display shows the last acknowledged status
call, or the first status in the list.
2 Perform one of the following actions:
• Use the keypad to enter a number
corresponding to the location in the status list.
3 Press the PTT button to send the status.
63
English
To Next Page
Loading...
Need help?
General
