temporarily remove the unwanted channel from the
scan list.
This capability does not apply to priority channels or
the designated transmit channel.
When the radio is locked onto the channel to be
deleted, or to Nuis and press the Menu Select
button directly below Nuis.
The radio continues scanning the remaining channels
in the list.
Restoring a Nuisance Channel
To restore the deleted nuisance channel, perform
one of the following actions:
• Stop and restart a scan.
• Mode change to another channel and back to
the original channel.
• Turn off the radio and then turn it on again.
Nuisance mode delete can be disabled by the
system administrator.
Changing Priorities Status While Scan is On
While the radio is scanning, the dynamic priority
change feature allows you to temporarily change any
channel in a scan list (except for the Priority-One
channel) to the Priority-Two channel.
This change remains in effect until scan is turned off.
Scan then reverts to the preprogrammed (original)
setting.
1
Press the Menu Select button directly below DYNP
to change the priority of a non-priority channel in
the scan list to Priority-Two.
2
Press momentarily to exit the scan list and
resume scanning.
Restoring Priorities in a Scan List
To restore the original channel priorities in a scan
list, perform one of the following actions:
• Turn scan off, and then on.
• Change channels.
• Turn off the radio, and then turn it back on.
79
English
To Next Page
Loading...
Need help?
General
